Skid's Place

Scale Model Building Website
 
HomeGalleryRegisterLog in


Share | 
 

 Louvers from the salvage yard

Go down 
AuthorMessage
Geezerman
Advanced Member
Advanced Member
avatar

Posts : 3375
Join date : 2013-02-24
Age : 82
Location : Gulf coast of central Florids

PostSubject: Louvers from the salvage yard   Wed 03 Jul 2013, 11:44 pm

My latest, a Model A , has the radiator in the trunk area. I'll need some air flow and heat transfer there, so looking thru my scrap yard  I came across some louvers. When I have leftover stuff from a kit, I'll put it in an appropriate bin, and usually forget the original source. So I don't recall where these particular ones came from. But I'm testing out how they will work.
First, I cut a slot just about 1/8 inch.


After I get a nice clean slot, I thin the edge, much like I thin away the thickness of a fender edge or hood cutout.


Then with super glue, I carefully glue the portion of louver in the center of the slot.



With a new #11 xacto blade, start removing the webbing between the ends of the louvers


The louvers are opened and I have plugged up the over cut at the top (even tho this is just a test).


A shot of primer and not too shabby. This is an simple operation, but it is a tad exacting. Might take a little patience, but if you're trying this, you're not expecting to just throw together a kit assembly, right?
Back to top Go down
Skid
Admin
avatar

Posts : 6712
Join date : 2013-02-15
Age : 69
Location : Newcastle. Good Old Blighty.

PostSubject: Re: Louvers from the salvage yard   Thu 04 Jul 2013, 12:25 am

Nice tute Clay. Thanks.

_________________
Al.

Success always demands a greater effort.” Winston Churchill

"Success is failure turned inside out"  Unknown
Back to top Go down
http://skidsplace.forumotion.co
Zbuckster
Senior member
Senior member
avatar

Posts : 6889
Join date : 2013-02-17
Age : 69
Location : Aberdeen, Washington

PostSubject: Re: Louvers from the salvage yard   Thu 04 Jul 2013, 2:25 am

Thanks Clay I will try that for sure. I think those louvers came in several of the old AMT kits as custom pieces. I can remember as a kid just gluing they to the body. With about 1/2 tube of glue of course. 001 
Back to top Go down
http://s1155.beta.photobucket.com/
Sponsored content




PostSubject: Re: Louvers from the salvage yard   

Back to top Go down
 
Louvers from the salvage yard
Back to top 
Page 1 of 1
 Similar topics
-
» Louvers from the salvage yard
» Jacks Junk yard
» Hollands Junk Yard finds
» Salvage rod #4
» JUNKYARDS OF NEW ENGLAND

Permissions in this forum:You cannot reply to topics in this forum
Skid's Place :: Help :: Quick tips-
Jump to: